The downside? They’re expensive. Like, really expensive, depending on which one you get. Whether you really need one depends on your budget and how you’re going to be using your ball. For example, I use official match balls for practising freekicks because they fly through the air really nicely. However, I don’t use them for training because if I lose my ball I’ll be set back $100-$300.

Our family has tried out a lot of value-priced soccer balls over the years. For example, this one was purchased as one of many, including some more expensive models by various manufacturers. But, funny enough, this is the one we always pick when it's time to play. It feels nice and plays nice. Maybe the balls are softer if you spend considerably more, but even at 2-3 times the cost of this ball, we like this one better. So, if you're looking for a soccer ball and you don't want to break the bank, stop searching, just get this one and know you got the right one.
Our main intention of finding the official match balls was to help you find a solution which is good in quality, and you can use it for league plays. The process was tough we must say. Not all the replica balls have good quality. That is why we were very choosy in the process. We filtered the balls not only based on our experience but also based on the experience of other users.
Inflate soccer balls to the pressure of 6-8 PPI (pounds per square inch). A pressure gauge will tell you when the air is enough. Under or over-inflating a soccer ball will shorten its life in one way or another. When under-inflated, the ball will not be resistant to the impact of kicks. On the other hand, over inflation will stretch out the bladder and put pressure on the panel stitches.

Latex bladders are one of the best materials when it comes to ball construction. However, with latex bladders, air won’t last as long as butyl bladders and will need more attention for proper inflation. Butyl-blend bladders hold in the air much better, but they are harder and less receptive in play. Mid-priced balls will usually have a mix of butyl and rubber.